SHOWTEC SM-16/2, Руководство пользователя

Страница: 10 / 21

8
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
RESETTING THE SYSTEM
Warning : this will reset the controller to its factory defaults. This will erase all programs and settings.
1) Turn off the unit.
2) Press and hold BANK UP and AUTO/DEL .
3) Turn on power to the unit (while still holding BANK UP and AUTO/DEL ).
4) All LEDs will blink to indicate a successful reset
note : this process may take up to 30 seconds
Warning:
This will reset the controller to its factory defaults. This will erase all programs
and settings.
FIXTURE ADDRESSING
The SM-16/2 is programmed to control 32 channels of DMX per fixture. Therefore, the fixtures you
wish to control with the corresponding “
FIXTURE ” buttons on the unit must be spaced 32 channels
apart (check the respective fixture’s manual for how to enter the information into the fixture).
Note: failure to use these DMX assignments may cause a lack of control of the fixtures.
FIXTURE OR
SCANNER
DEFAULT DMX
STARTING ADDRESS
BINARY DIPSWITCH SETTINGS
SWITCH TO THE “ON POSITION”
1 1 1
2 33 1,6
3 65 1,7
4 97 1,6,7
5 129 1,8
6 161 1,6,8
7 193 1,7,8
8 225 1,6,7,8
9 257 1,9
10 289 1,6,9
11 321 1,7,9
12 353 1,6,7,9