1.3
HOW TO USE THIS USER MANUAL
Carefully read the introduction, paying special attention to the SAFETY WARNING.
Read Section 2 describing how to design a system and how the hardware should be
installed.
Follow the instructions in Section 3 explaining settings for INTERFACE CARDS.
Section 4 describes how to install and operate the LEDstudio software
PLEASE READ ALL OF THIS USER MANUAL CAREFULLY BEFORE STARTING
INSTALLATION AND OPERATION
1.4
SETUP: QUICK REFERENCE
1- Install the LED SCREEN panels according to the instructions in Section 2.
2- Connect all cables as described in Section 2.3 and 3.4
3-Install the TRANSMITTER CARD in the PC and connect the TRANSMITTER CARD and
DISPLAY CARD as shown in Section 3.3
4 -Set the DISPLAY CARD settings as described in Section 3.6
5 -Set the RECEIVER CARD settings as shown in Section 3.5
6 -Install the LEDstudio software, refer to Section 4
7 -Verify that the HARDWARE SETUP settings in LEDstudio are correct by checking with
Section 4.3
8 -Test system setup using the tools in the <TEST> menu of the LEDstudio software.
1
INTRODUCTION
3
2006.6.28
