SHOWTEC gatactic RGB-600 value series, Руководство пользователя

Страница: 26 / 32

25
Ordercode: 51325
Galactic RGB-600 Value line
Problem Probable cause(s) Remedy
One or more
fixtures do not
function at all No power to the fixture ● Check that power is switched on and
cables are plugged in
Primary fuse blown ● Replace fuse
Fixtures reset
correctly, but all
respond erratically
or not at all to the
controller The controller is not connected ● Connect controller
3-pin XLR Out of the controller does
not match XLR Out of the first
fixture on the link (i.e. signal is
reversed) ● Install a phase reversing cable
between the controller and the first
fixture on the link
Fixtures reset
correctly, but
some respond
erratically or not at
all to the controller
Poor data quality ● Check data quality. If much lower than
100 percent, the problem may be a
bad data link connection, poor quality
or broken cables, missing termination
plug, or a defective fixture disturbing
the link
Bad data link connection ● Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables.
Data link not terminated with 120
Ohm termination plug ● Insert termination plug in output jack of
the last fixture on the link
Incorrect addressing of the fixtures ● Check address setting
One of the fixtures is defective and
disturbs data transmission on the
link ● Bypass one fixture at a time until
normal operation is regained: unplug
both connectors and connect them
directly together
● Have the defective fixture serviced by
a qualified technician
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed) ● Install a phase-reversing cable
between the fixtures or swap pin 2 and
3 in the fixture, that behaves erratically
Shutter closes
suddenly The laser diode has lost its index
position and the fixture is resetting
the effect ● Contact a technician for servicing the
problem persists
No light or laser
cuts out
intermittently
Fixture is too hot ● Allow fixture to cool
● Make sure air vents at control panel
and front lens are not blocked
● Turn up the air conditioning
Laser damaged ● Disconnect fixture and return to your
dealer
The power supply settings do not
match local AC voltage and
frequency ● Disconnect fixture. Check settings and
correct if necessary