SHOWTEC FX Shot MK II, Руководство пользователя

Страница: 17 / 20

16
Ordercode: 60906
FX Shot MKII
Maintenance
The Showtec FX Shot requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s performance will be significantly reduced. Disconnect the mains power supply
and then wipe the cover with a damp cloth. Do not use alcohol or solvents. Do not immerse in liquid.
Keep connections clean. Disconnect electric power, then wipe the connections with a damp cloth.
Make sure that the connections are thoroughly dry before supplying electric power.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert on regular basis in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
Troubleshooting
No blue LED Indicator
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
If the light effect does not operate properly, refer servicing to a technician.
Suspect two potential problem areas: the power supply or the Neutrik power cable.
01)
Power supply. Check that the unit is plugged into an appropriate power supply.
02) Check that the Neutrik power cable is properly connected and that the cable is not defective.
03) If all of the above appears to be O.K., plug the unit in again.
04) If you are unable to determine the cause of the problem, do not open the FX Shot, as this may
damage the unit and the warranty will become void.
05) Follow the steps below. If that doesn’t work return the device to your Showtec dealer.
A cannon does not fire
First turn off the power to the FX Shot and then walk towards the FX Shot.
Make sure the connector is properly connected to the cannon. If the blue LED indicator is lit and the
cannon does not fire, switch the cannon for another one and see if it does fire.
The FX Shot does not work even after checking the troubleshooting
If you are not sure about the operation of the FX Shot or other matters related to the FX Shot always
contact your dealer.
No Response to DMX from your controller
Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.