SHOWTEC FX Ice Jet, Руководство пользователя

Страница: 14 / 20

13
Ordercode: 61000
FX Ice Jet
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
The Showtec FX Ice Jet is designed to blow white CO
2
smoke streams.
As soon as the CO2 leaves the cylinder through the secured high-pressure hoses, it converts into gas.
This formation of gas is accompanied by a strong hissing sound, as well as a solid stream of smoke will be
visible.
The released smoke stream is approximately 8-meter long and depends strictly on current air
humidity.
The higher the humidity, the longer the smoke stream will be.
CO
2
gas has a temperature of -70º degrees !!
The proper use of the FX Ice Jet requires utmost safety and alertness!
In order to use the device in the proper way, act according to the following instructions:
Usage
01) Plug the FX Ice Jet’s power connector into the mains power supply.
02) The magnetic valve will immediately open and a white smoke plume will exit from the FX Ice Jet.
03) Unplug the device - the valve will immediately close.
Note: Never switch the device ON for more than 3 seconds.
This way you prevent dry ice from forming on the cannon tube and you will not cause an
accumulation of CO
2
in the room.
Switching Off
In order to switch the device OFF in the proper way, act according to the following instructions:
01)
Close the valve of the gas bottle.
02)
Activate the FX Ice Jet one more time to remove the remaining pressure from the hose.