SHOWTEC EVENTSPOT 60 Q7, Руководство пользователя

Страница: 29 / 36

28
Ordercode: 42727
Eventspot 60 Q7
Channel 20 – Auto speed ( CH19 must be set between 41-140 )
0-255 Speed adjustment, from slow to fast
Channel 21 – Dimmer speed
0-9 No function
10-29 Off (RGBW and Master dimmer linear)
30-69 DIM1 (fastest)
70-129 DIM2
130-189 DIM3
190-255 DIM4 (slowest)
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The Eventspot 60 Q7 requires almost no maintenance.
However, you should keep the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Switch off the device and then wipe the
cover with a damp cloth. Wipe the front glass panel clean with glass cleaner and a soft cloth. Do not use
alcohol or solvents. The front glass panel will require weekly cleaning, as smoke-fluid tends to build up
residues, reducing the light-output very quickly.
Do not immerse in liquid.
Keep connections clean. Make sure connections are thoroughly dry before linking equipment or
supplying electric power.
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect two potential problem areas: the battery and the LEDs.
01)
Battery. Check if the battery is fully charged.
02) The LEDs. Return the Eventspot 60 Q7 to your Showtec dealer.
03) If all of the above appears to be in order, switch the unit on again.
04) If you are unable to determine the cause of the problem, do not open the Eventspot 60 Q7, as this
may damage the unit and the warranty will become void.
05) Return the device to your Showtec dealer.
No Response to DMX
Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card
malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is to blame. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If it does, take the DMX cable and the
light effect to a qualified technician.