SHOWTEC EventBAR 100IR, Руководство пользователя

Страница: 18 / 32

17
Ordercode: 44100
EventBAR 100IR
07) Press the Setup button to set the speed or strobe value.
08)
Use the Up and Down buttons to set the speed and strobe value between 0-99 or SPFL .
Master / slave addressing
Master
01) The default setting for this device is master.
02) Only one fixture can be the master.
Note:
• Disconnect the fixture from the DMX controller before master/slave operating, otherwise data
collisions may occur and the fixtures will not work properly!
• In master/slave mode, the master fixture can execute the built-in programs, all the slave fixtures will
work the same.
• When operating the master/slave chain, you can identify the master fixture from the slave fixtures
easily. The master doesn’t have any cable plugged into the DMX input connector.
Slave control
This function allows you to control the slaves from the master’s control panel in a master/slave setup.
01)
Only 1 fixture can be the master, the others have to be Slaves. The Default setting for a device is
Master. So on the first device you don’t have to change anything.
On the slave devices you must press the Mode button until the display shows .
02) All slave devices must have address .
DMX Mode
With this menu you can set the DMX address and choose a DMX configuration.
01) Press the Mode button, until the display shows .
02) You can choose 512 different DMX addresses.
03) Use the Up and Down buttons to select the required address between .
04) You can also press the Setup button to choose a different DMX Mode . The
display will blink.
2 Channels
7 Channels
3 Channels
5 Channels
24 Channels