SHOWTEC EventBAR 100IR, Руководство пользователя

Страница: 12 / 32

11
Ordercode: 44100
EventBAR 100IR
One EventBAR 100IR ( Sound-control )
01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the EventBAR is not connected by a DMX-cable, it functions as a stand-alone device.
03) Turn on the music. If device is set to (Audio), then the fixture will react to the beat of the
music. Please see page 18 for more information about the Sound-controlled mode.
Multiple EventBARs 100IR ( Master/Slave control)
01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Use a 3-p XLR cable to connect the EventBAR and other devices.
The pins: 1. Earth
2. Signal (-)
3. Signal (+)
04) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units. You can use the
same functions on the master device as described on pages 16-17 (Auto run, Built-in Programs). This
means you can set your desired operation mode on the master device and all slave devices will
react the same as the master device.
Multiple EventBARs 100IR ( Master/Slave control)
Fig. 03