SHOWTEC Dynamic LED, Руководство пользователя

Страница: 9 / 21

7
Installation
Remove all packing materials from the LED Messenger. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
When the mounting bracket ( 1 ) isn’t fitted, you will first have to fit the mounting bracket in order to hang
it from a ceiling. You can also place this device on the floor.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.
Control Modes
There are 5 modes: • Select built-in Text programs
• Auto run (visual effects)
• Sound-controlled
• Master/Slave
• DMX512
One LED Messenger ( Built-in Text Programs )
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the LED Messenger is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 11 for more information about the built-in programs.
One LED Messenger ( Auto run visual effects )
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the LED Messenger is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 13 for more information about the Auto run visual effects.
One LED Messenger (Sound-control)
1. Plug the end of the electric mains power cord into a proper electric power supply socket.
2. Turn on the music. If the device is set to SOUN, then the LED Messenger will react to the beat of the
music. Please see page 13 for more information about the sound-control options .
Multiple LED Messengers ( Master/Slave control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the LED Messenger.
The pins:
1. Earth
2. Signal -
3. Signal +
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 14 (Built-in Programs,
Autorun or
Music control). This means on the master device you can set your desired operation Mode
and all slave devices will react the same as the master device.