SHOWTEC Dynamic LED, Руководство пользователя

Страница: 12 / 21

10
Control Panel
Fig. 5
A. LED Display E. Up Button
B. MENU Button F. Down Button
C. SETUP Button
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller.
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the LED Messenger will respond to the controller.
Please note when you use the controller, the unit has max.
3 channels.
When using multiple LED Messenger’s, make sure you set the DMX addresses right.
Therefore, the DMX address of the first LED Messenger should be
1(A001) ; the DMX address of the second
LED Messenger should be 1+3=4 ; the DMX address of the third LED Messenger should be 4+3=7 , etc.
Please, be sure that you don’t have any overlapping channels in order to control each LED Messenger
correctly. If two or more LED Messenger’s are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under ”Addressing’ (menu d001)
Controlling:
After having addressed all LED Messenger’s, you may now start operating these via your lighting
controller.
Note: After switching on, the LED Messenger will automatically detect whether DMX 512 data is received
or not.
The problem may be:
- The XLR cable from the controller is not connected with the input of the LED Messenger.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note:
It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.