SHOWTEC Dream Dancer DMX MKII V1, Руководство пользователя

Страница: 12 / 32

11
Ordercode: 42197
LED Lightbar 12 Pixel
Control Panel
A. LED Display
B. Mode button
C. Setup Button
D. Up Button
E. Down Button
Fig. 04
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the backside of the device allows you to assign the DMX fixture address, which is
the first channel from which the LED Lightbar 12 Pixel will respond to the controller. Please note when you
use the controller, the unit has up to
48 channels. When using multiple LED Lightbars 12 Pixel, make sure
you set the DMX addresses right. Therefore, the DMX address of the first LED Lightbar 12 Pixel should be
1(001) ; the DMX address of the second LED Lightbar 12 Pixel should be 1+48=49 (049) ; the DMX address of
the third LED Lightbar 12 Pixel should be 48+49=97 (097) , etc. Please, be sure that you do not have any
overlapping channels in order to control each LED Lightbar 12 Pixel correctly. If two or more LED Lightbars
12 Pixel are addressed similarly, they will work similarly.
Controlling:
After having addressed all LED Lightbars 12 Pixel, you may now start operating these via your lighting
controller.
Note: After switching on, the LED Lightbar 12 Pixel will automatically detect whether DMX 512 data is
received or not. The problem may be:
• The XLR cable from the controller is not connected with the input of the LED Lightbar 12 Pixel.
• The controller is switched off or defective, the cable or connector is defective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 20 seconds
When no button is pressed for 20 seconds, the display will turn off. To light up the display, you have to
press the
Mode , Setup , Up or Down button. Once you have pressed the button, the display will light up.
When the powercable is plugged in and you press the
Setup or Mode button immediately, the display
will show the temperature detection value. If the temperature is abnormal, the display will show ,
and the LEDs of the fixture will be red 3s.