SHOWTEC Dream Dancer DMX MKII V1, Руководство пользователя

Страница: 8 / 32

7
Ordercode: 42197
LED Lightbar 12 Pixel
Overview
Fig. 01
01)
IEC Power In
02) Ground/Earth connection
03) Fuse T1L / 250V
04) 12 x 4W RGBW
05) Menu B LED display
06) DMX signal connector (IN) 3-pin
07) DMX signal connector (OUT) 3-pin
08) IEC Power Out (max 10A)
09) Adjustment screw + mounting bracket for Truss mounting
Installation
Remove all packing materials from the LED Lightbar 12 Pixel.
Check that all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 6 modes: Built-in Programs
Auto Run
Sound-controlled
Manual control (Static)
Master/Slave
DMX512
One LED Lightbar 12 Pixel ( Built-in programs, Auto Run)
01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the LED Lightbar is not connected by a DMX-cable, it functions as a stand-alone device.
03) If device is set to or , then the fixture will play one of its built-in programs or show its
auto run mode. Please see pages 13-14 for more information about the built-in programs or auto run
mode.
One LED Lightbar 12 Pixel ( Sound-control )
01) Fasten the effect light onto firm trussing or place it on the floor. Leave at least 0,5 meter on all sides
for air circulation.
02) When the LED Lightbar is not connected by a DMX-cable, it functions as a stand-alone device.
03) Turn on the music. If device is set to (Audio), then the fixture will react to the beat of the
music. Please see page 15 for more information about the Sound-controlled mode.