23
ColorCue 4
Product code: 50706
Create a Scene (Single Control Mode)
Fig. 18
01)
Make sure that the device is in single (48-fixture) control mode. See 6.4. Control Modes on pages 18–
19 for more information.
02)
Set the master fader (K) to 0, if you do not want to output the scene live while you are creating it. If
you set the master fader (K) to any other value, any changes you make will be output live.
03)
Press one or more FIXTURES buttons (01)–(48) to select the fixture(s) you want to control. The LED(s) on
the button(s) will light up. If you want to have the same color for all connected fixtures, press all
FIXTURES buttons (01)–(48). If you want to have different colors for each of the connected fixtures,
select only one fixture at this step. You can also select multiple fixtures, if you want to have one color
on more than one fixture. The selected fixtures will be highlighted on the display.
04)
Slide the FIXTURES faders (01)–(48) to adjust the light intensity of the connected fixtures, selected in
step 3. The LEDs above the fixtures faders will light up.
05)
Make sure that the color selection mode is enabled. See 6.5.1.1. Color Selection Mode on page 19.
06)
Turn the controls (E)–(J) to select the desired color. The available colors are red, green, blue, white,
amber and UV. Turning the control clockwise will increase the color intensity. The display will show the
color value in the range 0–255. If you want to clear a selection, press the CLEAR button (68).
07)
If you want to select different colors for different fixtures, press the FIXTURES button(s) (01)–(48) once
again to cancel the selection of the fixture(s) you have made in step 3. The LED(s) on the button(s)
will turn off. Do not do steps 7 and 8, if you have selected the same color for all connected fixtures.
08)
Repeat steps 3–6 to select colors for the remaining fixtures.
09)
Slide the BANK A master fader (K) to 100 to output the scene. Do not do this step, if you have already
set the BANK A master fader (K) to 100.
Transition between Scenes (Single Control Mode)
01)
Create a scene following the instructions in 6.6.4. Create a Scene on page 23.
02)
Press the HOLD button (65) to hold the output colors and intensities of the connected fixtures. The LED
on the button will light up.
03)
Set the output colors and intensities for the next scene. The new values will not be output.
04)
Press the HOLD button (65) once again to output the scene. The LED on the button will turn off.
05)
Repeat steps 1–4 to create each time a new scene and to transition between the two scenes.
Note:
Transitioning between scenes in single (48-fixtures) mode is without crossfading.
Содержание 50706
Страница 13: ...12 ColorCue 4 Product code 50706 Dimensions Fig 05 Fig 06 Mounting Dimensions Fig 07...
Страница 36: ...2021 Showtec...
