SHOWTEC 42567, Руководство пользователя

Страница: 23 / 28

22
Ordercode: 42567
Wipe Out 3W
Problem Probable cause(s) Remedy
One or more
fixtures do not
function at all. No power to the fixture. ● Check if power is switched on and
cables are plugged in.
Primary fuse blown. ● Replace fuse.
Fixtures reset
correctly, but all
respond erratically
or not at all to the
controller. The controller is not connected. ● Connect controller.
3-pin XLR Out of the controller does
not match XLR Out of the first fixture
on the link (i.e. signal is reversed). ● Install a phase reversing cable between
the controller and the first fixture on the
link.
Fixtures reset
correctly, but some
respond erratically
or not at all to the
controller.
Poor data quality ● Check data quality. If much lower than
100 percent, the problem may be a
bad data link connection, poor quality
or broken cables, missing termination
plug, or a defective fixture disturbing
the link.
Bad data link connection ● Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables.
Data link not terminated with 120
Ohm termination plug. ● Insert termination plug in output jack of
the last fixture on the link.
Incorrect addressing of the fixtures. ● Check address setting.
One of the fixtures is defective and
disturbs data transmission on the
link. ● Bypass one fixture at a time until normal
operation is regained: unplug both
connectors and connect them directly
together.
● Have the defective fixture serviced by a
qualified technician.
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed). ● Install a phase-reversing cable between
the fixtures or swap pins 2 and 3 in the
fixture.
No light or lamp
cuts out
intermittently
Fixture is too hot. ● Allow fixture to cool.
● Make sure air vents at control panel
and front lens are not blocked.
● Turn up the air conditioning .
LEDs damaged ● Disconnect fixture and return to your
dealer.
The power supply settings do not
match local AC voltage and
frequency. ● Disconnect fixture. Check settings and
correct if necessary.