SHOWTEC 42567, Руководство пользователя

Страница: 12 / 28

11
Ordercode: 42567
Wipe Out 3W
The Wipe Out can be operated with a controller in control mode or without the controller in stand-alone
mode .
Control Panel
A)
B)
C)
D)
E)
LCD Display
MODE button
SETUP Button
UP Button
DOWN Button
Fig. 04
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller.
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Wipe Out will respond to the controller.
Please note when you use the controller, the unit has
16 channels.
When using multiple Wipe Outs, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Wipe Out should be
1(001) ; the DMX address of the second Wipe
Out should be 1+16=17 (017 ); the DMX address of the third Wipe Out should be 17+16=33 (033) , etc.
Please, be sure that you do not have any overlapping channels in order to control each Wipe Out
correctly.
If two or more Wipe Outs are addressed similarly, they will work similarly.
Controlling:
After having addressed all Wipe Out fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Wipe Out will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the problem may be:
• The XLR cable from the controller is not connected to the input of the Wipe Out.
• The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 30 seconds
When no button is pressed for 30 seconds, the display will turn off.
To light up the display, you have to press the MODE, SETUP, UP or DOWN button.
Once you have pressed the button, the display will light up.