16
- Master / slave addressing
- Master
1)
Press Choose, until the display shows
or
(with actually stored address).
2)
If the display shows message
(with actually stores address).
Select Down, the display shows
.
Select Enter, the display shows “
, (with actually stored address).
If you want to address no master or slave, don’t select
.
3)
Only one fixture can be the master. Up to the 16 slaves may be connected to the master.
Note
: Disconnect the fixture from the DMX controller before master/slave operating, otherwise data
collisions can occur and the fixtures will not work properly!
In master/slave mode, the master fixture can execute the built-in program
and the remote
control function
, all the slave fixtures will work the same.
In master/slave mode, the built-in program ID prior to the remote control function.
When operation, you can identify the master fixture from the slave fixture easily. The master doesn’t
connect any cable to the DMX input plug. When execute the remote control, the display of the
master will
flash according to the music, while the display of the slave will light.
You can also use the Pan invert
and Tilt invert
. It doesn’t matter whether you choose -Y or –n,
when using Pan invert or Tilt invert.
4)
Make sure that the settings for
,
,
are the same for the Master unit and the Slave units.
- Slave control
This function allows you to control the slaves from the master’s control panel in a master/slave operation.
1)
Press Choose, until the display shows
or
(with actually stored address).
2)
If the display shows message
(with actually stores address).
Select Down, the display shows
.
Select Enter, the display shows “
, (with actually stored address).
If you want to address no master or slave, don’t select
.
3)
In Slave mode, the slave units should be set to
and
.
Note
: Disconnect the fixture from the DMX controller before master/slave operating, otherwise data
collisions can occur and the fixtures will not work properly!
4)
Select this function from the main menu and press Choose until the display shows
(with actually stored address)
5)
In master/slave mode, the setting of
,
,
for the slave units, must be the same as the master
unit.
Pan invert
and Tilt invert
can be set to –Y or -n.
Содержание 40137
Страница 1: ...Phantom Wash HTI 150 V2 ORDERCODE 40164...
Страница 23: ......
