18
Ordercode: 30749
Edison Bar E6
No Response to DMX
Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02)
Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03)
Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.
Problem
Probable cause(s)
Remedy
One or more fixtures
do not function at
all.
No power to the fixture.
●
Check if power is switched on and
cables are plugged in.
Primary fuse blown.
●
Replace fuse.
Fixtures reset
correctly, but all
respond erratically
or not at all to the
controller.
The controller is not connected.
●
Connect controller.
3-pin XLR Out of the controller does
not match XLR In of the first fixture
on the link (i.e. signal is reversed).
●
Install a phase reversing cable
between the controller and the first
fixture on the link.
Fixtures reset
correctly, but some
respond erratically
or not at all to the
controller.
Poor data quality.
●
Check data quality. If much lower than
100 percent, the problem may be a
bad data link connection, poor quality
or broken cables, missing termination
plug, or a defective fixture disturbing
the link.
Bad data link connection.
●
Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables.
Data link not terminated with 120
Ohm termination plug.
●
Insert termination plug in output jack of
the last fixture on the link.
Incorrect addressing of the fixtures. ●
Check address setting.
One of the fixtures is defective and
disturbs data transmission on the
link.
●
Bypass one fixture at a time until
normal operation is regained: unplug
both connectors and connect them
directly together.
●
Have the defective fixture serviced by
a qualified technician.
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed).
●
Install a phase-reversing cable
between the fixtures or swap pin 2 and
3 in the fixture, that behaves erratically.
No light or lamp
cuts out
intermittently.
Fixture is too hot.
●
Allow fixture to cool.
●
Make sure air vents are not blocked.
●
Turn up the air conditioning.
Lamp damaged.
●
Disconnect fixture and replace the
lamp.
The power supply settings do not
match local AC voltage and
frequency.
●
Disconnect fixture. Check settings and
correct if necessary.
Содержание Edison Bar E6
Страница 21: ...20 Ordercode 30749 Edison Bar E6 Dimensions ...
Страница 22: ...21 Ordercode 30749 Edison Bar E6 Notes ...
Страница 23: ...22 Ordercode 30749 Edison Bar E6 ...
Страница 24: ... 2019 Showtec ...
