Shop-Vac H87 SERIES, Руководство пользователя

Страница: 6 / 36

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.
UNPACKING
ASSEMBLY
TOOL HOLDER
ASSEMBLY
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
5. Remove tank cover, refer to dry pick up or wet pick
up operation in user manual to ensure you have the
proper filters installed for your cleaning operation.
6. Replace tank cover, and apply pressure with thumb to
each latch until it snaps tightly into place. Make certain
all lid latches are clamped securely.
7. Insert machine hose end with locking-nut into inlet of
tank. Turn locking nut to tighten. Do not over-tighten.
8. Insert adapter into hose
end then attach wand or
accessory to other end
of adapter depending on
your cleaning application.
Twist slightly to tighten the
connection. FIGURE 3.
9. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF.
NOTE:
Many more useful tools are available at your
local dealer or Shop-Vac ® website.
GENERAL SET UP
FIGURE 3
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
10. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models)
instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag (not
standard with all models) must be used with the
cartridge filter.
PAGE 5
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
Questions?
U.S. Customers call
888-822-4644
or visit
www.shopvac.com
24 hours a day.
Canadian Customers
call
905-335-9730
or visit
www.shopvac.ca
24 hours a day.
NOTE:
Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
1. Replace tank cover and apply pressure with thumbs
to each latch until it snaps tightly in place. Make sure
both lid latches are clamped securely.
2. With rear of unit facing you,
take tool holder and position it
with the tabs facing rear tank
cover. FIGURE 1 .
3. Press tabs of tool holder
into the slots on mounting
lugs on rear of tank cover.
FIGURE 2
.
4 . Press down until tabs snap into place.
FIGURE 1
FIGURE 2