Shop fox W1836, Руководство пользователя

Страница: 22 / 48

-20-
Model W1836 (For Machines Mfd. Since 04/15)
O
PE
R
ATIO
NS
This lathe has two overlapping speed ranges to ensure
maximum spindle torque within each range. These ranges
are selected by changing belt positions on the motor and
spindle pulleys (see
Figure 15
).
High range (
B) is best when turning a workpiece where a
clean finish is required and only light cuts are made. Low
range (
A), which has more torque, is best when turning a
workpiece where a lot of material must be removed and a
rough finish does not matter. Use the speed dial to adjust
the spindle speed within each range.
Refer to the speed recommendations chart below to
choose the appropriate RPM for your operation. Then
choose the speed range that will include the selected
RPM.
Always choose correct spindle speed
for your operation. Using an incorrect
speed may lead to workpiece breaking
loose or being thrown from lathe at
a high rate of speed, causing fatal or
severe impact injuries.
Diameter of
Workpiece
Roughing
RPM
General
Cutting RPM
Finishing
RPM
Under 2" 1520 3000 3000
2–4" 760 1600 2480
4–6" 510 1080 1650
6–8" 380 810 1240
8–10" 300 650 1000
10–12" 255 540 830
Changing.Spindle.Speeds
(Viewed from Front of Headstock)
Low Range
500–1800 RPM =
= High Range
1000–3800 RPM
A
B
Spindle
Motor
1. DISCONNECT MACHINE FROM POWER!
2. Fold back belt cover to expose spindle pulley. Pull
access door release knob and open access door to
expose motor pulley (see Figure 16).
3. Loosen belt tension lock handle. Move belt tension
lever up to reduce tension on belt.
4. Locate desired speed on belt-cover speed chart, and
move belt to desired grooves on motor and spindle
pulleys.
Figure 15
. Belt position for each spindle
speed range.
Figure 16. Location of components used
when changing spindle speed ranges.
Belt
Cover
Access
Door
Access Door
Release Knob
Belt Tension
Lever
Belt Tension
Lock Handle
Changing.Spindle.Speed.Range