Shop fox M1048, Руководство пользователя

Страница: 32 / 48

-30-
M1048 10" x 18" Metal Cutting Bandsaw
SE
RV
IC
E
The blade guide bearings are adjusted at the factory
but due to shipping and storage may need adjustment.
Use Figures 37 & 38 to guide you through the following
steps.
To adjust the blade guide bearings, do these steps:
1.
Before making adjustments, make sure the blade is
tensioned and tracking correctly.
2. DISCONNECT THE BANDSAW FROM POWER!
3. Raise the bow high enough to give you room to work,
then lock in place.
4.
Remove both blade guards.
5.
The back of the blade (A) in
Figure 37
should make
light contact with the backing bearing (C).
— If it does not, loosen the set screw (B) shown in
Figure 37,
and move the bearing (C) up or down
until it lightly touches the back of the blade.
The blade guide roller bearings also need to be adjusted.
The front bearing is mounted on an eccentric and can be
easily adjusted to suit the blade thickness.
To adjust the blade guide roller bearings, do these
steps:
1.
Loosen the set screw in
Figure 38
to allow the
eccentric bushing to turn.
2. Turn the square nut on the eccentric shaft to adjust
the distance of the guide bearing. The guide bear-
ings and blade should make light contact or have a
maximum clearance of 0.002".
3.
Adjust the carbide blade guides so they make the
same contact with the blade as the bearings.
4. Adjust the eccentric blade guide rollers bearing on
the front arm the same way.
Blade Guide Bearings
Figure 37. Blade guide adjustments.
Eccentric Bushing
Carbide Blade Guide
Figure 38.
More blade guide adjustments.
A
B
C
Set Screw
Guide Bearings