-8-
D2260A Mini Mobile Base Instructions
9.
With the help of an assistant, lift the rear side of
the machine up, then place a 4x4 block under the
machine.
10.
Slide each of the corner brackets into the remaining
rail and slide the assembly over the block and up
against the machine, as shown in
Figure 19
.
Note:
This rail is the same size as the one you
installed on the front of the machine between the
corner brackets with the foot posts.
Figure 19.
Fixed casters and rail placed
around back of machine, which is raised
up with a wood block.
11.
Fasten the corner brackets to the rail with (4)
M8-1.25 x 16 hex bolts, and 8mm lock nuts, as shown
in
Figure 20
.
Tip:
Thread the hex bolts into the rails but do
not tightening the lock nuts against the rails until
instructed.
12.
Remove the rear rail-corner bracket assembly from
the 4x4 block.
13.
While the assistant steadies the machine, remove
the 4x4 block, then set the machine on the ground.
14.
Put on safety glasses, use a crowbar and some type
of fulcrum to raise one of the side rails that is
attached to the front corner bracket assembly, then
place a 6" 2x4 under the rail to support it, as shown
in
Figure 21
.
15.
Repeat
Step 14
to place another 6" 2x4 under the
rail on the opposite side of the mobile base.
16.
Carefully lean the machine toward the front of the
mobile base, making sure there are no large gaps
between the machine and the front rail-corner
bracket assembly.
Figure 20.
Rear rail–fixed caster assembly
secured.
x 4
Figure 21.
2x4 placed under rail after
using crowbar to raise rail up.
Front Rail-Caster
Assembly
6" 2x4
12" 4x4
