-7-
D2260A Mini Mobile Base Instructions
Figure 16.
Corner bracket-rail assembly
placed under front of machine.
6.
Slide the other pair of rails that are of identical
size into the ends of the corner brackets from
Step
5
, then fasten with (4) M8-1.25 x 16 hex bolts, and
8mm lock nuts, as shown in
Figure 15
.
Tip:
Thread the hex bolts into the rails but do
not tighten the lock nuts against the rails until
instructed.
Figure 15.
Rails fastened to brackets.
(Machine removed from assembly for
clarity.)
7.
While an assistant lifts one side of the machine up,
slide the front rail-bracket assembly from
Step 6
under the machine, as shown in
Figure 16
.
Note:
It may be necessary to readjust the position
of some of the fasteners once the machine is
actually on the base assembly.
8.
Mount each fixed caster to a corner bracket with the
eight hole pattern using (4) M8-1.25 x 16 hex bolts,
8mm flat washers, 8mm lock washers, and M8-1.25
hex nuts, as shown in
Figure 17
.
Orient the fixed casters so they point in the same
direction that your machine will typically be moved
(see
Figure 18
). Mounting the fixed casters in the
wrong direction will make it difficult to move your
mobile base.
Note
:
Patience is required when installing the
fasteners inside the bottom of the fixed casters due
to space constraints.
Figure 18.
Mounting casters based upon
typical direction of movement.
Kpg`ZXc;`i\Zk`fef]Dfm\d\ek
KFGM@<NF=:8JK<I
:FII<:K
@E:FII<:K
x 4
Figure 17.
Options for mounting fixed
casters to eight hole pattern corner
brackets.
OR
x 4
x 4
