SHOEI Neotec II, Инструкция по эксплуатации, Страница: 7 / 12

13
12
The QSV-1 sun visor can be opened and
closed by sliding the sun visor lever on
the left side of the shell. To open the sun
visor, pull the lever down until it stops in
the position shown in the drawing. If the
sun visor is not fully open, it may slip down
and close unexpectedly during riding due to
vibration or other phenomena and your view
may be obstructed.
Removing the QSV-1 Sun Visor
1. Open the face cover. See “Opening and Closing
the Face Cover.”
2. Lower the QSV-1 sun visor.
3. Hold the sun visor and use service tool to widen
the space between the sun visor holder and the
sun visor as per Drawing 1. Detach the sun visor
by rotating it in the direction shown by the arrow.
4. Follow the same procedure for the other side.
Installing the QSV-1 Sun Visor
1. Slide the sun visor lever to the position shown in
the drawing 2 and hold it not to move the holder.
2. As shown in Drawing 2, insert the convex part 1
at the bottom edge of the QSV-1 sun visor into
the holder. While rotating the sun visor upward,
press the rounded part 2 of the sun visor into the
holder until you hear it clicks.
3. Follow the same procedure for the other side.
4. Remove any fingerprints on the sun visor by
wiping with a soft, dry cloth.
Removing the QSV-1 Sun Visor Installing the QSV-1 Sun Visor
WARNING
If the sun visor is not installed properly, it may drop
unexpectedly during riding and obstruct the rider’s
vision. After installing the QSV-1 sun visor, raise
and lower the visor several times to confirm that the
protruding section of the sun visor is fit securely in
the holder’s opening. Confirm that there is no space
between the sun visor and the holder.
Applying Silicone Oil
Service Tool
English
QSV-1 Sun Visor
1 2
2
1
Applying the enclosed silicone oil to lubricate the
helmet’s moving parts, such as the face cover and
shield/visor pivot points. First, remove any dirt or dust
then apply a small amount of oil to the designated
part as per drawing. Wipe away any excess oil.
Check for adequate lubrication regularly.
Service tool is the tool to be used in following cases.
• Removing sun visor
(Refer to “Removing the QSV-1 Sun Visor.”)
• Removing intercom base cover
(Refer to “When Installing the Intercom.”)
• Adjusting PINLOCK ® EVO lens
(Refer to the Drawing.)
When adjusting PINLOCK
®
EVO lens, read the
instruction manual that comes packed with it.
Service Tool
Service Tool