11
10
WARNING
If the hook and gear are not securely fastened in the
shield/visor base, the shield/visor may come loose while
riding and an accident may unexpectedly occur. After
installing the CNS-3 shield/visor, open and close the
shield/visor a few times to confirm that the hook and
gear fit securely. With the shield/visor completely closed,
confirm that the shield/visor tab is clasped by the hook.
Installing the CNS-3 Shield/Visor
1. Adjust the shield/visor to fully opened position
(Drawing 4) and insert hook B into the gear (Drawing
5).
2. Press hook A and C as per Drawing 6 to fix hooks
into the hook rail.
3. Follow the same procedure to install the other side.
4. Confirm that the shield/visor hook and gear fit
properly into the shield/visor base.
4
5
6
WARNING
CNS-3 tinted shield/visor is not for sale or use in
USA. If tinted shield/visor and sun visor are used
together in USA, requirement of light transmission
ratio specified in VESC-8* is not satisfied. Don’t use
tinted shield/visor to your helmet in a manner not
satisfying VESC-8*. Otherwise, your vision restricted
by tinted shield/visor may cause an accident and
serious injury or death.
VESC-8: Vehicle Equipment Safety Commission
regulation No. 8 for motorcyclist eye protection
This standard is widely referenced and applied
by the 36 states in USA with motorcyclist eye
protection use law.
z
z
Dirt and scratches on the shield/visor may obstruct
your view while riding and can be very dangerous!
If the CNS-3 shield/visor gets dirty or scratched,
stop using it immediately. Remove the shield/visor
and clean or replace it.
z
z
The CNS-3 shield/visor should be cleaned with a
solution of mild, neutral soap and water. Rinse well
with pure water then wipe dry with a soft cloth.
Do
not use any of the following cleaning materials:
hot water over 40ºC; salt water; any acidic or
alkali detergent; benzine, thinner, gasoline, or
other organic solvents; glass cleaner; or any
cleaner containing organic solvents.
If any
of these cleaners are used, the shield’s/visor’s
chemical nature may be altered and safety may be
hindered.
z
z
Do not ride with a shield/visor that is fogged.
This may obstruct your view and can be very
dangerous. If the CNS-3 shield/visor is fogged,
open the lower air intake to circulate air within the
helmet and remove the fog from the shield/visor.
z
z
Remove the protective film before using the shield/
visor for the first time.
z
z
Do not place any sticker or tape in the shield’s/
visor’s field of vision.
Important Notice about Handling the
CNS-3 Shield/Visor
Shield/Visor
Hook B
Gear
Shield/Visor
Hook C
Hook rail
Hook A
Trigger