9
8
The breath guard reduces fogging of the shield/visor
caused by breathing.
To install the breath guard, use the following
procedure.
Installing the Breath Guard
As shown in the drawing, insert the breath guard
in the space between the shell and the impact
absorbing liner.
Removing the Breath Guard
Pull the breath guard from the space between
the shell and the impact absorbing liner. When
you pull out the breath guard, the back side of the
window beading may come off. If this happens, grab
the window beading between the thumb and the
forefinger and return it to its location.
The ear pads are designed to reduce wind noise.
The ear pads can be removed. To remove or install
the ear pads, see the “Removing and Installing Inner
Parts” section.
If you pull the CNS-3 shield/ visor completely down, the
shield/visor tab will clasp the hook. We recommend that
you use the shield/visor in this position while riding your
motorcycle.
1
3
2
Removing the CNS-3 Shield/Visor
1. Open CNS-3 shield/visor to the fully opened position
(Drawing 1).
2. While pulling the trigger down, lift and turn the shield/
visor upward by holding the bottom edge to release
hook A (Drawing 2). When hook A is released, hook
B is also released at the same time.
3. Pull the shield/visor to the direction shown in Drawing
3 and release hook C.
4. Follow the same procedure to remove the other side.
With the ear pads are installed, the sound
from nearby vehicles will be reduced.
Please be aware of this while riding.
Do not carry or hold the helmet by the
breath guard. The breath guard may come
off, causing the helmet to drop.
Before using the shield/visor for the first time
after purchase, remove the protective film from
the shield/visor.
Breath Guard
CNS-3 Shield/Visor
Ear Pads
Shield/Visor tab
Hook
Shi
el
d/visor
Hook C
Hook A
Hook C
Hook A
Trigger
Hook rail
Hook B