19
6 Settings
6.1 Setting of controller
Controllers should to be set as the following.
(Refer to the instruction manual for the controller connected to the LMD-100.)
(1) Controller communication protocol :
Shinko protocol
(2) Controller instrument number
:
From 1 in numerical order
(e.g.) Set from 1 to 5 when 5 units of controller are
connected.
(3) Controller communication speed :
19200bps
6.2 Turn the power supply to the LMD-100 ON (warm-up indication)
Turn the power supply to the LMD-100 ON.
After power-on, the PV display indicates “
” for approx. 5 seconds. (Fig. 6.2-1)
After that, the LMD-100 reads PV, SV and alarm status of the connected controller,
and indicates them for each channel (in the case of automatic switching of the channel
number, the channel is automatically switched every 2 seconds.). (Fig. 6.2-2)
(Fig. 6.2-1)
(Fig. 6.2-2)
6.3 Display explanation
In this manual, the following display is used for purposes of explanation.
means no indication.
(e.g.) Set value memory selection
Display
CH
MEMO
PV
SV
(Fig. 6.3-1)
