ASSEMBLY
T302X
24
X7502350302
© 10/19 ECHO Incorporated
Nylon Line Head Installation
Wear Gloves or personal injury may result:
◆
Cutoff knife is sharp.
◆
Gearcase and surrounding area may be hot.
Speed Feed Head
1.
Make sure shield with cutoff
knife and upper plate are
properly installed.
2.
Align hole in upper plate with
notch in edge of gear housing
and insert head locking tool (H)
3.
Thread line head (I) onto PTO
shaft by turning it
counterclockwise until head is
tight against upper plate.
4.
Remove locking tool (H).
Semi-automatic nylon line heads must be used only with debris
shield with cut-off knife. Using nylon line heads with debris shield
without cutoff knife can result in trimmer damage, caused by
operation with excessive line length.
Note: Your nylon line head may appear different than nylon line
head shown.
Parts Required:
Speed Feed Head.
I
H
H