Shindaiwa DH232ST-24, Руководство оператора

Страница: 19 / 120

17
Hedge and shrub trimming operation
Hedge and shrub trimming operation
Rotating operation
This model is equipped with a twistable rear handle feature that
can be turned 90° to either side of the normal operating position
to help reduce operator fatigue and improve precision trimming
during vertical cutting operations.
To operate:
1. Fully release the throttle trigger.
2. Lift up the twist handle release lever.
3. Rotate the handle 90° in the desired direction and release
the lever. Make sure that the handle is fully locked into posi-
tion before use.
Basic hedge trimming operation
Œ
Pulling the throttle trigger after the engine is started will cause
the engine speed to rise and the cutter blades to start moving.
Adjust the engine speed depending on, for example, the
amount of the hedges to be cut.
ΠConduct cutting work with the cutter blades positioned away
from you. Do not orient the cutter blades toward yourself or put
it closer to yourself.
ΠWhen cutting the top of the hedges or shrubs, do so by moving
the cutter blades from side to side. Tidy trimming will be made
possible by moving the blades slightly cast down.
ΠWhen cutting sides, do so by moving the cutter blades in the
bottom-up direction for tidy trimming.
ΠDo not press the cutter blades against the objects like trees.
Operate the product in accordance with the movement and the
speed of the cutter blades.
ΠReleasing the throttle decreases engine speed, causing the
cutters to slow, and then stop altogether as the clutch disen-
gages.
ΠAvoid cutting material larger than 1.27 cm in diameter.
1. Release lever
2. Rear handle 3. Throttle trigger
WARNING
 
Never fail to stop the engine before rotating operation!
‹ Failure to observe these instructions will cause the product
to be held unsteadily and could result in serious injury.
NOTE
The throttle trigger will not operate when the rear handle is not
fully locked into position.
1. Throttle trigger
2. High speed 3. Idling