background image

LightOWL® Dual Technology Passive Infrared 

and Acoustic Sensors (LODIA)

INSTALLATION INSTRUCTIONS

Page 1 of 8

 Rev 04/11/23

WWD2-2_InstallSheet_R01

currentlighting.com

© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change 
without notice. All values are design or typical values when measured under laboratory conditions.

WWD2-2IW

Installation Guide

Product Overview

 

RISK OF ELECTRIC SHOCK

Disconnect power before servicing or installing product .

WARNING

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save these instructions for future use.

IMPORTANT

To ensure the product warranty is valid, please ensure

all installation instructions and environmental conditions

for storage and operation are complied with.

Installation to be performed by factory trained or qualified

personnel.

Save These Instructions

Use only in the manner intneded by the manufacturer.

If you have any questions, contact the manufacturer.

Prepare Electrical Wiring

¥When replacing a line voltage switch, the

power must be off at the branch circuit

breaker. Bypass the line voltage switch to

provide uninterrupted power to the fixtures

and make sure the connection is properly

insulated before installing the wireless switch.

intended

The WWD2-2IW wireless dimmer is a battery powered 
in-wall mount switch for use in zonal room control 
or as part of a large wireless networked system. The 
WWD2-2IW device installs into an existing junction 
box to replace an existing switch providing a wire-
less solution that enables dimming and ON/OFF           
commands to be delivered to luminaires in its com-
missioned space. The communication with the lumi-
naires or wireless controllers utilizes a secure a reliable 
wireless connection which helps minimize installation 
cost and complexity.

Electrical Requirements

Содержание WWD2-2IW









Отзывы: