Shindaiwa DG100MI, Руководство владельца и оператора

Страница: 37 / 52

34
(1) Engine Oil Replacement
First Time 50 hours
Thereafter Every 200 hours
Set a container to catch spilled engine oil.
Remove the oil filler cap.
After removing the oil drain plug and packing,
open the oil drain faucet and drain the engine
oil.
After the oil has been drained,close the oil drain
faucet and reinsert the oil drain plug with
packing.
Add oil through the oil filler until it is at the
maximum level while checking the oil level using
the oil level indicator.
Attach the oil filler cap.
< Note >
 Refer to section “
8-1. Checking Engine Oil
” for
engine oil replacement amounts and types.

After reinserting the oil drain plug and shortly after
starting the engine, be sure to always check that there is no oil leakage.
(2) Replacing the Oil Filter
First Time 50 hours
Thereafter Every 400 hours
Drain the engine oil. (Refer to section
“(1) Engine Oil
Replacement”
.)
Remove the oil filter using a filter wrench.
Spread a thin layer of oil on a new oil filter gasket.
Thread the oil filter by hand until the gasket contacts the seal
surface. (Do not use a filter wrench.) Tighten it by 2/3 turn
using the filter wrench.
Add engine oil to the generator.
Shortly after starting the engine, always be sure to check
that there is no oil leaking from the seal surface.
< Note >

Request the authorized distributor where the generator was purchased to perform this procedure
if you do not have a filter wrench.

Oil filter part no.: 1132402322(ISUZU part no.)
Oil Level
Indicator
Oil Filler
Cap
Oil Drain Plug
Packing
2
3
4
5
6
2
4
Gasket
5
6
Oil Drain Faucet
Oil Drain Plug
Close
Open
3
1
Oil Drain
Faucet
（
inside
）
Oil Filter
1