Shindaiwa DG100MI, Руководство владельца и оператора

Страница: 31 / 52

28
< Note >

Check that the surrounding area is safe before starting the engine.

When there are multiple workers who are working together, they must mutually signal each other
before starting the engine.

Do not use in an area with high temperature or humidity, or an area with a large amount of dust.

Do not open any doors during operation. Operating with door open can negatively affect cooling
effect, resulting in an equipment malfunction.

Use ear protection if the level of noise is high. Failure to do so could result in hearing damage.

Please be careful about a strong wind and the opening and shutting of the door at the sloping
place enough. A door is open suddenly and is closed, and a finger might be sandwiched.
Turn the circuit breaker for 3-phase and 1-phase to
OFF.
Set the throttle lever to IDLING.
Turn the starter switch to START position, and
start the engine.
In cold environment, turn the starter switch to
PREHEAT position, wait until the preheat lamp
comes on, and start the engine.
< Note >

The preheat lamp will be turned on
in 25 seconds
and it indicates completion of preheating.

Do not continuously operate the starter motor for 10 sec. or
more.

If repeating starter switch operation, wait 30 sec. or more
between re-starting.

Be aware that smoke might be generated when the engine
is started.
After starting the engine, remove your hand from the starter switch.
Let engine idles for approximately for five minutes.
Set the throttle lever to RUN
and adjust frequency with the frequency adjust screw.
Rated frequency No-load frequency
50Hz(1500min
-1
) 52.5Hz(1575min
-1
)
60Hz(1800min
-1
) 63.0Hz(1890min
-1
)
Adjust the voltage regulator dial to the specified voltage.
50Hz Operation 200V [400V]
60Hz Operation 220V [440V]
* The values in brackets are for when set to 400/440V.
Turn the breaker to ON to start AC power delivery.
5
6
7
8
1
2
3
4
1-Phase Circuit Breaker
Throttle
Lever
Starter
Switch
3-Phase
Circuit
Breaker
Preheat
Lamp
Frequency
Adjust Screw