Shindaiwa 269T, Инструкция по эксплуатации

Страница: 21 / 28

21
SERVICE
•
If you have any questions or troubles, please contact
shindaiwa dealer.
CARBURETTOR
• Do not adjust the carburettor unless necessary.
• To adjust the carburettor proceed as follows:
− Low speed mixture adjuster (L): 1 to 1 and 1/4
turns open
−
High speed mixture adjuster (H): 1 to 1 and 1/4
turns open
−
Screw in the needles until lightly seated and
return indicated turn above.
• Turn idle speed adjuster (T) clockwise until chain
begins to rotate. Then back screw 1/2 turn.
FUEL FILTER
• Check periodically.
− Do not allow dust to enter fuel tank.
− Clogged filter will cause difficulty in starting
engine or abnormalities in engine performance.
− Pick up the fuel filter through fuel inlet port with a
piece of steel wire or the like.
−
When the filter is dirty, replace it.
−
When the inside of the fuel tank is dirty, it can be
cleaned by rinsing the tank out with petrol.
AIR FILTER
• Check before every use.
• Loosen cleaner cover knob and remove air cleaner
cover and filter.
Brush off dust lightly, or clean with compressed air,
or replace the air filter.
•
Reinstall filter and cover.
OIL FILTER
•
Check periodically.
−
Do not allow dust to enter oil tank.
− Clogged oil filter will affect the normal lubricating
system.
− Pick it up through oil filling hole with a piece of
steel wire or the like.
−
If the filter is dirty, wash it in petrol or replace it.
−
When the inside of the oil tank gets dirty, it can be
cleaned by rinsing the tank out with petrol.
CAUTION
When starting, idle speed adjuste (T)should be
adjusted not to rotate the saw chain.
When there is some trouble with the carburettor,
contact your distributor or dealer.
WARNING DANGER
PETROL AND FUEL ARE EXTREMELY
FLAMMABLE.
EXTREME CAUTION IS REQUIRED, WHEN
HANDLING PETROL OR FUEL.
Oil filter
Fuel filter
Air cleaner cover
Cleaner cover knob
Air filter
L: Low speed mixture
adjuster
H: High speed mixture
adjuster
T: Idle speed
adjuster