Shindaiwa 269T, Инструкция по эксплуатации

Страница: 20 / 28

20
SERVICE MAINTENANCE GUIDE
TROUBLE SHOOTING
Trouble
Engine
−
starts hard
−
does not start
Cause Remedy
Engine
cranks
Fuel at
carburettor
No fuel at
carburettor
• Fuel filter clogged
• Fuel line clogged
• Carburettor
• Clean or replace
• Clean
• Ask your shindaiwa dealer
Fuel at cylinder No fuel at
cylinder
•
Carburettor
•
Ask your shindaiwa dealer
Silencer wet
with fuel
•
Fuel mixture is too rich
•
Open choke
•
Clean/replace air filter
•
Adjust carburettor
•
Ask your shindaiwa dealer
Spark at end of
plug wire
No spark at end
of plug wire
• Ignition switch off
• Electrical problem
• Turn switch on
• Ask your shindaiwa dealer
Spark at plug No spark at plug
•
Spark gap incorrect
• Covered with carbon
• Fouled with fuel
• Spark plug defective
•
Adjust 0.6 to 0.7 mm
• Clean or replace
• Clean or replace
• Replace plug
Engine
does not
crank
•
Internal engine problem
•
Ask your shindaiwa dealer
Engine
runs
Dies or
accelerates
poorly
•
Air filter dirty
•
Fuel filter dirty
•
Fuel vent plugged
•
Spark plug
• Carburettor
• Cooling system plugged
• Exhaust port/silencer
plugged
•
Clean or replace
•
Clean or replace
•
Clean
•
Clean and adjust/replace
• Adjust
• Clean
• Clean
AREA MAINTENANCE PAGE BEFORE USE
MONT
MONTHLY
Air Filter Clean/Replace 21 •
Fuel Filte Inspect/Clean/Replace 21 •
Spark Plug Inspect/Clean/Adjust/Replace 22 •
Carburettor Adjust/Replace and adjust 21 •
Cooling System Inspect/Clean 22 •
Silencer Inspect/Tighten/Clean
−
•
Oil Filter Inspect/Clean/Replace 21 •
Sprocket Inspect/Replace 22 •
Chain Brake Inspect/Replace 15 •
Starter Rope Inspect
−
•
Guide Bar Inspect/Clean 22 •
Fuel System Inspect/Repair 6 •
Screws, Bolts and Nuts Inspect, Tighten/Replace
−
•
IMPORTANT
Time intervals shown are maximum. Actual use and your experience will determine the frequency of
required maintenance.
WARNING DANGER
ALL CHAIN SAW SERVICE, OTHER THAN ITEMS
LISTED INTHEOPERATOR’SMANUAL SHOULD
BE PERFORMED BY COMPETENT SERVICE
PERSONNEL.