Note:
When removing
the sensor cable,
do not apply too
much force when
pulling the cable,
otherwise the
sensor may
become damaged.
Use a tool to hold
the sensor in place
and pull the cable
out carefully.
Maintenance
Bracket and lever disassembly
1.
Remove the sensor cap,
and the use a 2 mm Allen
key to remove the lever
stud set screw on the
bottom of the bracket.
Lever stud set screw
2 mm Allen key
Sensor cap
2.
Insert a 2.5 mm Allen key or similar tool into the lever
stud hole, and tap it gently with a plastic mallet to push
out the lever stud. When the lever stud comes out, the
bracket body and lever body can be disassembled.
After this, pull the sensor cable out from the bracket
body.
Sensor
Sensor cable
Bracket
body
Lever body
➁
➀
Lever and bearing assembly
disassembly
5 mm Allen key
Special tool (TL-ST01)
Torque tightening during assembly:
8 - 10 N·m {70 - 85 in. lbs.}
1.
Remove the cable hook.
2.
Disassemble using the special tool and
a 5 mm Allen key.
Cable hook
