ENGLISH
System Setup
37
• The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most
situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be
changed later.
The setup menu consists of 6 main menus ; system, input, speaker, CH level, parameter and HDMI.
These menus are then divided up into various sub-menus.
■
Note:
• Only when an input source other than “NET/USB” is selected, you can perform the system setup procedure.
■
Navigating through the setup menu
• The explanations here assume you are using the buttons on the remote control when performing the setup menu operation.
However, you can use the buttons on the front panel as well.
The buttons on the front panel correspond to those on the remote control as shown below.
SETUP
ENTER / MEMO
PRESET
TUNE
MAIN MENU
MA
MENU
I N
S S
Y
E T
2 6
U P
T E M S
AT
• The setup menu will be shown.
• To turn the menu off, press this button again.
• When selecting "SYSTEM SETUP", see "SETTING THE
SYSTEM SETUP" on page 39.
• When selecting "INPUT SETUP", see "SETTING THE
INPUT SETUP" on page 41.
• When selecting "SPEAKER SETUP", see "SETTING THE
SPEAKER SETUP" on page 42.
• When selecting "CH LVL SETUP", see "SETTING THE
CH LEVEL SETUP" on page 46.
• When selecting "PARAMTER SETUP", see "SETTING
THE PARAMETER SETUP" on page 48.
• When selecting "HDMI SETUP", see "SETTING THE
HDMI SETUP" on page 50.
• When selecting "EXIT", the setup menu will be turned off.
1.
Turn the setup menu on.
2.
Select the desired menu using the CURSOR
UP(
▲
)/ DOWN(
▼
) buttons.
3.
Confirm your selection.
RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 37
