250-300 SE-R
12
REMOVING/INSTALLING THE ENGINE
❱❘
Reinstalling the engine
The installation of the engine back into the frame should follow in reverse order the way it was removed. Note
the torque value of all of the mounting bolts:
Engine mounting bolts: 60Nm (44 lb-ft)
Swingarm nut: 100 Nm (74 lb-ft)
Clutch save cylinder bolts: 10 Nm (7.4 lb-ft)
Cylinder head bracket bolts: 23 Nm (17 lb-ft)
- Make sure the tensioning cables are completely
relaxed.
- Adjust the top position cable n°1 on the cable
pulley and in the cable stop located on the
cylinder.
For the lower cable n°2, put it in the cable stop
without any tension.
Turn the bike ignition switch ON.
Wait until the electric motor initializes the
valves and then shuts down.
Turn the bike ignition switch OFF.
- Start adjusting the upper cable tensioner n°3 by
unscrewing the 8 nut…
…in order to obtain 10.2mm +-0.2 as shown
here.
CAUTION
Be careful when installing the engine. The cable tension of the exhaust valve control mechanism is very critical to
the proper operation of the engine. Followthese steps in order to properly adjust the cables.
Содержание 250 SE-R 2017
