EXPENSE data transferred between the
and the ZQ-1000 series is stored on the receiving unit
without payment type data.
When transferring EXPENSE data by mode from the
ZQ-1000 series to the
an
DEVICE
ERROR” may occur. This will occur when there is not
enough memory space to be assigned as the area for
payment type data; EXPENSE data from the ZQ-1000
series does not have this space. If the error occurs, delete
unnecessary data on the
to increase the
amount of free memory, then transfer the data again. Once
an
DEVICE ERROR” occurs, all EXPENSE data
transferred to the
before the error is
cleared.
When transferring EXPENSE data by mode from the
ZQ-1000 series to the
no data
verification can be carried out.
Transferring
data
by mode or by entry
To transfer an entry,
Recall the entry to be transferred on the transmitter.
Note: To perform mode transfer, select the mode by
pressing the mode key, and then press
It is not
necessary to display an entry.
2. Select the data transfer function on the receiver, and set it
26
in the receive mode by pressing (MENU],
then 2.
3. Select the data transfer function on the transmitter and
perform data transfer by pressing
2 then
Notes:
l
Follow the same steps to transfer data from another ZQ or
an IQ series Organizer.
l
Notes described on page 25 also apply here.
Verification
Follow the steps explained in “Transferring data between
Organizers” above.
Transferring data with an EL series
Organizer (including Auto Dialer)
For the EL-6100 series Organizer, TEL data and SCHEDULE
data can be transferred. For the EL-6260 Auto Dialer, TEL data
can be transferred. Data is transferred by mode or by entry.
Data transfer restrictions
When transferring data with an EL series Organizer (including
the Auto Dialer), the following restrictions apply:
When transferring data to an EL series Organizer
l
Transferred data is added to previously stored data.
