Sharp XV-Z10E, Руководство по эксплуатации

Страница: 33 / 73

-31
Basic Operation
Using the Adjustment
Feet
The height of the projector can be adjusted us-
ing the adjustment feet at the front and rear of
the projector when the screen is not perpen-
dicular to the lens centre of the projector, or
when installation surface is slightly slanted.
When the screen is in a higher position than
the projector, the projection image can be made
higher by adjusting the projector.
1
Press the HEIGHT ADJUST button.
•
The front adjustment foot comes out.
2
Lift the projector to adjust its
height while pressing the HEIGHT
ADJUST button.
•
The projector is adjustable up to approxi-
mately 12 degrees (5 steps).
•
When lowering the projector, it may be
difficult to move the front adjustment foot
because the installation surface is difficult
to slide. In this case, pull the projector back
slightly and adjust its height.
3
Remove your hands from the
HEIGHT ADJUST button of the
projector after its height has been
finely adjusted.
4
Use the rear adjustment foot to
make the projector level.
•
The projector is adjustable
±
1 degree from
the standard position.
Note
•
When the height of the image is being adjusted
by the adjustment feet, the image becomes dis-
torted trapezoidally. In this case, see “Correct-
ing Trapezoidal Distortion” on page
29 to cor-
rect the trapezoidal distortion.
Info
•
Do not press the HEIGHT ADJUST button
when the front adjustment foot comes out
without firmly holding the projector.
•
Do not hold the lens when lifting or lowering
the projector.
•
When lowering the projector, be careful not to
get your fingers caught in the area between
the adjustment foot and the projector.
HEIGHT ADJUST
button
HEIGHT ADJUST button
Front adjustment
foot
Rear adjustment
foot
XV_Z10E_E_p26_35.p65 03.11.7, 4:15 PM 31