Sharp XL-HF202PH, Руководство по эксплуатации

Страница: 28 / 32

E-19
Enhancing your system
The connection lead is not included. Purchase a commer-
cially available lead as shown below.
Audio cable (not supplied)
Portable audio
player, etc.
■
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player, etc. to the AUDIO IN socket.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO/LINE (INPUT) button (remote con-
trol) or FUNCTION button repeatedly (main unit) to
select AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■
Headphones
●
Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
●
Before plugging in or unplugging the headphone, re-
duce the volume.
●
Be sure your headphone has a 3.5 mm (1/8”) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
●
Plugging in the headphone disconnects the speakers au-
tomatically.
Troubleshooting chart
If something is wrong with this product, check the following
before calling your authorised SHARP dealer or service
centre.
■
General
Symptom Possible cause
●
The clock is not set to
the correct time.
●
A power failure occurred.
Reset the clock. (Refer
page 6)
●
When a button is
pressed, the unit does
not respond.
●
Set the unit to the power
stand-by mode and then
turn it back on.
●
If the unit still
malfunctions, reset it.
(Refer page 21)
●
No sound is heard.
●
The volume level set to
“Min”.
●
The headphones are not
connected.
●
The speaker wires are not
connected.
●
The unit is too for from the
Bluetooth stereo audio
source device.
●
The unit is not paired with
the
Bluetooth
stereo audio
source device.
■
Remote control
Symptom Possible cause
●
The remote control
does not operate.
●
The AC power lead of the
unit is not plugged in.
●
The battery polarity is
wrong.
●
The batteries are dead.
●
The distance or angle is
incorrect.
●
The remote control sensor
receives strong light.
■
NFC / Bluetooth
Symptom Possible cause
●
No sound is heard.
●
The unit is too far from the
Bluetooth
stereo audio
source device.
●
The unit is not paired with
the Bluetooth stereo audio
source device.
●
Bluetooth sound
is interrupted or
distorted.
●
The unit is too near to
a device that generates
electromagnetic radiation.
●
There is an obstacle
between the unit and the
Bluetooth stereo audio
source device.