E-25
6. Select input.
Press the INPUT SELECT button on the projector to
switch the picture input. When you press the button, the
current input mode is displayed for about 4 seconds. If
you press the button again while the input mode is
displayed, the mode changes as shown on the left.
Confirm the selected input terminal and press the INPUT
SELECT button.
Notes:
•
This can be selected directly using the VIDEO 1, VIDEO 2, DATA1 and
DATA2 buttons on the remote control.
•
In VIDEO mode, the system being received will be indicated below the
“VIDEO” display.
•
When selecting RGB mode, the resolution being displayed will be
indicated under “RGB,” as shown on the left. (Refer to the second
example when connecting to Mac display.)
•
When no signals are being received, “NO SIGNAL” will be displayed.
When receiving a signal the projector is not preset to receive, “NOT
REG.” will be displayed. (This display function does not operate in
Video mode.)
•
The picture size differs in RGB, NTSC, PAL and SECAM INPUT
modes.
7. Press INPUT CHECK.
When the INPUT CHECK button on the remote control is
pressed, the current input mode is displayed for about 4
seconds.
Note:
•
The INPUT CHECK button will not function if the INPUT DISPLAY is
turned off, as described on page 30.
8. Adjust the volume.
Press the VOLUME UP-DOWN buttons on the projector
or on the remote control to adjust the volume.
MUTE
•
Press the MUTE button to temporarily turn off the
sound.
•
Press the MUTE button once again to turn the sound
back on.
9. To turn off the power from the projector
or remote control
The power can be temporarily turned off by pressing the
POWER ON/OFF button on either the projector or remote
control.
The POWER indicator will turn red and the cooling fan
will run for 90 seconds, then the power will turn off,
and the projector will return to STANDBY mode.
The power can be turned on again either from the
projector or remote control. When the power is turned
on, the POWER indicator and LAMP REPLACEMENT
indicator light green.
Note:
•
When the MAIN POWER is off on the projector set, the power cannot
be turned on from the remote control.
On-Screen Display
For viewing the picture from a
video source connected to: VIDEO
INPUT 1 or S-VIDEO INPUT
COMPUTER
RGB2
COMPUTER
RGB1
VIDEO INPUT 2
V O L U M E
3 8
The number of displayed
segments (0~60) increases or
decreases as the volume is
raised or lowered.
ON/OFF
POWER
LAMP
TEMP.
Mac
Mac
