E-17
ANALOG RGB OUT
OUTPUT
INPUT1
RGB
COMPUTER
Connecting to the Computer RGB Input (RGB 1)/Output (RGB 1, 2) Terminals
■
You can connect your projector to a computer for easy projection of full-color computer images, and an external
monitor for simultaneous viewing.
■
Use the RGB 1 input connector and the supplied RGB cable for Plug & Play.
RGB Signal
Cable
(Supplied)
RGB Signal
Output Socket
1
1. Connecting to an IBM-PC (VGA, SVGA,
XGA, SXGA) Series computer – 1,280
×
1,024 maximum resolution
Plug the RGB signal cable correctly into the RGB INPUT
terminal on the projector and into the RGB signal output
terminal on the computer, and secure the plugs by
tightening the thumb screws.
Note:
•
This connection is possible only when using a computer with a VGA/
SVGA/XGA/SXGA or Mac display output port.
Side view of the projector
RGB Signal
Input Socket
IBM-PC (VGA,
SVGA, XGA,
SXGA)
Series (computer)
2
1
Macintosh Adaptor (Supplied)
2. Connecting to a Macintosh Series
Computer
•
640
×
480, 832
×
624 or 1,024
×
768 resolution
1
Set the proper switches on the supplied adaptor.
• For 640
×
480 resolution, set switches 1 and 2 to
“ON” and 3, 4, 5 and 6 to “OFF”.
• For 832
×
624 resolution, set switches 2 and 4 to
“ON” and 1, 3, 5 and 6 to “OFF”.
• For 1,024
×
768 resolution, set switches 2 and 3 to
“ON” and 1, 4, 5 and 6 to “OFF”.
2
Connect the supplied Macintosh adaptor to the RGB
signal output terminal on your Macintosh Series
computer, as shown on the left, and secure the plugs
by tightening the thumb screws.
3
Firmly plug the supplied RGB signal cable into both
the RGB input terminal on the projector and the
Macintosh adaptor on the computer, and secure the
plugs by tightening the thumb screws.
Notes:
• Be sure to use the supplied Macintosh adaptor.
• Be sure the switches on the adaptor are properly set.
• Once the adaptor is connected to a computer and the computer is
turned on, the display mode cannot be changed even if the switches
on the adaptor are reset.
• The supplied adaptor is only for use with H-SYNC and
V-SYNC output. When connecting a Macintosh Series computer that
only outputs C-SYNC, use a special C-SYNC output adaptor (sold
separately).
ON
↑
↓
OFF
Side view of the projector
OUTPUT
INPUT1
RGB
COMPUTER
RGB Signal
Input Socket
Macintosh Adaptor (Supplied)
Macintosh
3
ANALOG RGB OUT
RGB Signal
Output Socket
Macintosh
RGB Signal Output Socket
RGB Signal
Cable
(Supplied)
ANALOG
RGB OUT
2
