Sharp VL-PD6H Quick operation, Руководство по эксплуатации

Страница: 18 / 116

Preparation
Preparation
9
Charging the Battery Pack
Charge the battery pack with the supplied AC
adapter/battery charger before use.
Note:
• Remove the DC cable from the AC adapter/
battery charger when charging the battery pack.
1
Connect the supplied power cord to the
AC power socket on the AC adapter/
battery charger, and insert the AC plug
into a power outlet.
• The POWER indicator lights up.
Charging time and maximum continuous
tape recording and tape playback times
Charging
time
90
140
Max.
continuous
recording time
Max.
continuous
playback
time
on LCD
100
200
Battery
pack
BT-LS222
BT-L221
BT-L441
BT-LS442
• The chart specifies the approximate times in
minutes.
Notes:
• Charge the battery pack at a temperature of 10°C
to 30°C. The battery pack may not charge
properly at temperatures too low or too high.
• The battery pack and charger become warm
during charging. This is not a malfunction.
• Using the zoom (see page 20) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than 50%
in the actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may vary
depending on the ambient temperature and the
condition of the battery pack.
• See page 97 for more information on using the
battery pack.
Caution:
• Charge only SHARP model BT-LS222, BT-L221, BT-
L441, or BT-LS442 battery packs. Other types of
battery packs may burst, causing personal injury
and damage.
Extending battery pack life
Even when the battery pack is not used, the
capacity of the battery pack will naturally
deteriorate over time. To limit the deterioration of
the capacity, it is recommended to perform the
following procedure at least once every six
months:
Q Charge the battery pack until the CHARGE
indicator of the charger goes off.
W Attach the battery pack to the camcorder, and
set the Power switch to CAMERA without
inserting a cassette. Allow the battery power to
fully discharge by leaving it on the camcorder
until the camcorder power automatically turns
off.
E Remove the battery pack and store it at a
temperature of 10°C to 20°C.
LCD
closed
120
240
LCD
open
100
200
Preparation
Q
W
CHARGE indicator
Q
W
E E
To power
outlet
AC power socket
POWER indicator
• The CHARGE indicator goes off when
the battery is fully charged.
3
When charging is complete, slide the
battery pack in the direction of the arrow
(
Q
), and remove it (
W
). Then, remove
the AC plug of the power cord from the
power outlet.
2
Align the ƒ mark on the battery pack
with the ∂ mark on the charger ( Q ) and
guide the battery into the groove.
Pressing the battery (
W ), slide it in the
direction of the arrow (
E
) until it locks
into place.
• The CHARGE indicator lights up.
VL-PD6H/009-018 01.4.24, 0:24 PM 9
Downloaded from: http://www.usersmanualguide.com/