Sharp VC-A136X, Руководство по эксплуатации

Страница: 22 / 25

When the DISPLAY
button is pressed, the display changes in the following way. (However, the following is the case
when the clock time is set and displayed in the system.)
Example:
[TAPE COUNTER/CHANNEL]
NOTE:
l
During timer recording or Simple Recording Timer, the display shows the record finish time. When the DISPLAY button is pressed,
the display changes in the following way
Example:
[RECORD FINISH TIME] Example:
[PRESENT TIME]
Example:
Example:
REMAINING TIME]
NOTE:
l
During Simple Recording Timer recording, the timer position number is not displayed, and lights instead of “TIMER”.
Counter Clear
Make sure the counter is displayed, then press the
C L E A R
button on the remote control. is displayed.
NOTE:
l
The counter will reset to 00” when the tape is rewound completely.
the DISPLAY button on the remote control.
VCR Display
NOTES:
l
When you insert the tape and the VCR is in the stop mode, the tape
remaining cannot be computed. The following indicator is shown
when the tape remaining has not yet been computed or cannot be
computed.
l
When you start recording or playback, the VCR will begin the computation. However, this may take some time.
When computation is completed, tape remaining will be shown on the VCR display for 5 seconds.
l
If the “REM.” mode is selected with the DISPLAY button, the tape will automatically fast forward or rewind for a few seconds and
then the VCR will begin computing the amount of tape remaining.
l
During computation, the REC button will not function, and pressing the STOP, or other buttons will interrupt the
computation.
Setting the DPSS or ZERO-BACK function during computation may cancel it.
l
The indicated length of tape remaining is only an approximate guide.
l
This function may not work properly when you use a video tape other than E240, or E180.
l
The length of tape remaining during fast forward or rewind may be indicated as greater than it actually is.
l
When and tapes are used with a cassette adapter, the indication may not be correct.
Warning for the length of tape remaining
When the tape reaches the point where only about five minutes of recording time is left, the remaining
length of tape will be automatically displayed, as a warning.
NOTE:
l
No warning, however, will be shown during timer recording or Simple Recording Timer recording.
21