Sharp UX-A1000, Руководство по обслуживанию

Страница: 18 / 128

UX-A1000U
2 – 6
6. 7. IJP list mode
Maintenance data of the printer is output.
[Details of maintenance data]
Item Clear timing Updata timing
Dot counter At the replacement cartidge After printing
Page counter At the replacement cartidge After printing
Number of head cleaning (Wiping of cartridge) At the initial cartridge setting At the maintenance
Replacement counter of the cartridge At the initial cartridge setting At the replacement of cartridge
Jam counter At the initial cartridge setting At every paper jam
6. 8. Printer error check mode
The cause of “PRINTER ERROR” message is displayed.
[Details of Display]
Display Cause of “PRINTER ERROR” message
PRINTER ERR 01 Power on reset response was not received from printer.
PRINTER ERR 02 Printer interface ASIC data buffer was full and not resume for 180sec.
PRINTER ERR 03 Carrier was not reached to cap position for 15sec after cover closed.
PRINTER ERR 04 NPA command was not forwarded to printer for 5sec.
PRINTER ERR 05 Printer interface ASIC command buffer error was occurred during NPA command forwarding.
PRINTER ERR 06 NPA response was not received for 5sec.
PRINTER ERR 07 Printer interface ASIC response buffer error was occurred during NPA response receiving.
PRINTER ERR 08 ESC* command was not forwarded to printer for 5sec.
PRINTER ERR 09 Printer interface ASIC command buffer error was occurred during ESC* command forwarding.
PRINTER ERR 10 Print data transfer from Printer interface ASIC to printer was not completed for 180sec.
PRINTER ERR 11 Last printed page was not exited for 60sec.
PRINTER ERR 12 Carrier was not reached to cap position for 60sec after last printed page was exited.
PRINTER ERR 13 Alignment pattern or Clean nozzles pattern printing was not completed for 60sec.
PRINTER ERR 14 Printer interface ASIC print data bit error was occurred.
PRINTER ERR 15 Printer interface ASIC print data DRAM writing error was occurred.
PRINTER ERR 21 Reserved
PRINTER ERR 22 Reserved
PRINTER ERR 23 Reserved
PRINTER ERR 24 Carrier stall error
PRINTER ERR 25 Printer PWB NVRAM error
PRINTER ERR 26 Printer could not output print data.
PRINTER ERR 27 Printer head short error
PRINTER ERR 31 Received NPA response was not for "Loop Back" command.
PRINTER ERR 32 Received NPA response was not for "Register For DSA" command.
PRINTER ERR 33 Received NPA response was not for "Print Head Information" command.
PRINTER ERR 34 Received NPA response was not for "Set Alignment Data" command.
PRINTER ERR 35 Received NPA response was not for "Get Printer Firmware Version" command.
PRINTER ERR 36 Received NPA response was not for "Printer ROM & RAM Check" command.
PRINTER ERR 37 Received NPA response was not for "Printer ROM Checksum" command.
PRINTER ERR 38 Received NPA response was not for "Cartridge Initial" command.
PRINTER ERR 39 Received NPA response was not for "Default Cartridge" command.
PRINTER ERR 40 Received NPA response was not for "Reset Wipe Count" command.
PRINTER ERR 41 Received NPA response was not for "Reset Page Count" command.
PRINTER ERR 51 Invalid command parameters was forwarded to printer.
PRINTER ERR 52 No supported command was forwarded to printer.
PRINTER ERR 53 Forwarded command was rejected by printer.
2 – 6