Sharp UA-KIL60E, Руководство по эксплуатации

Страница: 20 / 172

EN-18
1. Remove the Back Panel and the
Dust Box.
2. Remove the Pre-Filter Lock.
3. Remove the Shaft.
4. Remove the Cap and pull out the
Pre-Filter from the Shaft.
Pre-Filter Lock
1
1
2
Tab (orange)
①
1
2
4
Shaft (lower)
Shaft (upper)
3
Shaft
Pre-Filter
Cap
1
1
2
2
5. Soaking and cleaning the Pre-Filter.
1. Add a small amount
of kitchen detergent
to water and soak for
about 10 minutes.
2. Rinse off the kitchen
detergent with clean
water.
3. Dry it thoroughly.
6. Insert the Pre-Filter shaft into the
groove of the Shaft.
7. Attach the Shaft (upper) to the Back
Panel.
8. Roll up the Pre-Filter.
Pre-Filter
NOTE
• Do not clean it too hard. Do not wash it with a
washing machine. (Otherwise it might cause
damage.)
• Do not dry it with a dryer. (Otherwise it might
cause shrinkage.)
1
1
2
2
Shaft (upper)
1
2
Shaft (lower)
Click, Click, ...
Pre-Filter
PRE-FILTER
(Only UA-KIL80E)
EN-19
ENGLISH
PRE-FILTER
(Only UA-KIL80E)
NOTE
• Do not clean with anything other than the Unit
Cleaning Brush. Doing so could lead to failures in
the Unit.
• A bent electrode could be cut off and dropped
during the cleaning process, but it will not change
the performance.
• Do not touch the electrode directly. Doing so could
lead to pain / itching.
• Do not transform the Electrode Section. Doing so
can damage it.
• Do not touch the Connection Terminals. Doing so
can damage them.
Connection Terminals
1. Remove the Unit Cover, and pull out
the Unit Holder.
2. Remove dusts from the Electrode
Section.
3. Insert the Unit Holder in the product,
and install the Unit Cover.
Click
PLASMACLUSTER ION
GENERATING UNIT
(Electrode Section)
Unit Cleaning Brush
Electrode
After cleaning
Before
cleaning
Around the base
Electrode
Unit Cleaning
Brush
9. Pull down the Shaft (lower) and
attach it to the Back Panel.
10. Install the Pre-Filter Lock.
11. Install the Dust Box and the Back
Panel.
Shaft (lower)
1
2
1
1
2
2