4
Please check the following before calling for service!
1. Plug the power cord into a three-pronged electric-outlet. (See page 5)
2. Place one cup of water in a glass measure in the oven and close the door securely.
A. Does the oven light come on?
Yes _________No
________
B. Does the cooling fan work?
Yes _________No
________
(Put your hand over the back ventilating opening.)
C. If “No”, please check wall outlet and circuit breaker.
3. Touch these pads:
A. Does the “ON” indicator come on?
Yes _________No
________
B. At the end of 1 minute, is the water hot?
Yes _________No ________
IF SERVICE IS NEEDED, PLEASE CONTACT YOUR NEARE
ST AUTHORIZED SHARP SERVICER.
SERVICE CALL CHECK
ERROR MODE
Should any of the error indicators appear in the readout, follow the instructions:
★
EE Mode
Reason
Action Required.
EE 1, EE 2
Failure of single magnetron
Call for service.
EE 3
Both magnetrons failed
Call for service.
EE 4
Voltage too high
If problem is not corrected, call an
electrician.
EE 5
Voltage too low
If problem is not corrected, call an
electrician.
EE 7
Check that nothing is blocking air intake open-
ings on oven back or that oven exterior is
very hot. Correct. Wait a few minutes and try
again. If problem persists, call for service.
EE 8
Circuite failure Call for service.
EE 9
Maximum time is exceeded
Check page 11 in the Operation Manual.
Press the STOP/CLEAR pad, and reprogram
correctly.
EE 0
Cooling fan motor failure
Call for service.
Any time the EE appears, the servicer should be called. To cancel error indicator, press the Stop/Clear
pad.When EE does not appear, check the reason and correct. Service is not necessary.
Flashing of cooking time
When the remaining cooking time in the reabout is flashing, it means the temperature of the food
is too high. At that time, please stop the oven and check the food.
1 0 0
EE 1 and EE 2: In case of single magnetron failure, oven can be used until servicing by changing
Custom Help settings to allow operation under single magnetron only (see page
19). However, check food carefully as additional cooking time will be needed when
operating with a single magnetron.
★
SELECT TIME
START
Oven cavity or components
temperature too high