8
MAKING COPIES
USING THE RADF
The RADF (Reversing Automatic Document Feeder)
will handle A5 to A3 (5-1/2" x 8-1/2" to 11" x 17")
sized originals.
●
Before loading originals into the document feeder
tray, be sure to remove any staples or paper clips
from them. The RADF can handle a maximum of 50
originals.
●
Damaged or crumpled originals may misfeed in the
RADF. It is recommended that these be copied
from the document glass and the copies be used as
original documents.
●
When feeding originals which have closely spaced
binding holes punched along an edge, place the
originals so that the punched edge is positioned to
the right or along the side guides.
●
Special originals such as transparency film and
tracing paper should not be fed from the RADF, but
should be placed on the document glass.
●
Duplex copying will not work when a non-standard
sized paper is used.
●
Different size originals with the same width can be
placed in the document feeder tray and automati-
cally copied onto their respective sized copy paper.
The automatic copy ratio selection will not function
in this case.
●
If 8-1/2" x 11"R (A4R) originals are set into the tray,
they will be sensed to be A4R (8-1/2" x 11"R).
●
Image void can occur at the leading edge (max. 3
mm (1/8")) and the trailing edge (max. 4 mm (5/32"))
of the copies.
1-sided copies of 1-sided originals
1
Adjust the original guides to the size of the originals
and set the originals face up in the document feeder
tray.
●
The original size will be indicated in the message display, and
the paper tray with the corresponding paper size will be
selected.
●
If an original is left on the document glass, the original
reminder indicator will blink. Remove the original from the
document glass in this case.
●
If copy paper of the required size is not installed in any of the
trays, the following message will appear.
LOAD PAPER.
If a tray of the required size is not installed, use the manual
feed tray and press the TRAY SELECT key to select the
manual feed tray.
●
To copy onto a different size paper, use the TRAY SELECT
key to make the selection.
Using the RADF
Stream feeding mode
If the stream feeding mode has been enabled using key operator
program P47, the original feed indicator will continue to blink for
approximately 5 seconds after feeding of all originals is
completed. While this indicator is blinking, any new originals
placed in the document feeder tray will be fed and copied
automatically.
★
KEY OPERATOR
See page 122 for information on setting the
stream feeding mode.
Содержание SF-2052
