R-351NW
11 - 7
4. SEALER FILM
1. Put the adhesive tape on the backing
fi
lm of the sealer
fi
lm
as shown in Fig. C-7
2. Tear the backing
fi
lm by pulling the adhesive tape.
3. Put the pasted side of the sealer
fi
lm on the door panel
3. After any service, make sure of the following:
1. Door latch heads smoothly catch latch hook through latch
holes and that latch head goes through center of latch hole.
2. Deviation of door alignment from horizontal line of cavity
face plate is to be less than 1.0mm.
3. Door is positioned with its face pressed toward cavity face
plate.
4. Check for microwave leakage around door with an approved
microwave survey meter. (Refer to Microwave Measurement
Procedure.)
NOTE:
The door on a microwave oven is designed to act
as an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be
air-tight, moisture (condensation)-tight or light-tight.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around
oven door is not abnormal and do not of themselves
indicate a leakage of microwave energy from oven
cavity.
Figure C-6. Door Replacement
Pin
Pin
Upper
Oven Hinge
Upper Oven
Hinge
Lower Oven
Hinge
Lower
Oven Hinge
Slit choke of
door panel
Choke Cover
Figure C-7. Sealer film
Sealer film
Backing film
Adhesive tape
Service_R-351NW.indd 30
Service_R-351NW.indd 30
6/26/09 6:30:57 PM
6/26/09 6:30:57 PM
