MX-M182 SIMULATIONS 7-9
07
01
Warm-up display and aging with jam detection
Used to measure the warm-up time and execute aging with jam detection.
When this simulation is executed, the following warm-up window is displayed.
The time required for starting the warm-up and completing the initializing operation and shifting to the stand-
by state is displayed.
After completion of warm-up, press [CA] key to exit the simulation mode, allowing normal copy operations.
The copy mode at that time is the aging mode with 0sec of intermittent aging.
Canceled by turning off the power or executing a simulation which makes the hardware reset. When the
interruption is pressed to shift to the input standby window, the machine does not enter the aging mode.
06
Intermittent aging
Used to execute intermittent aging of 3sec. The set quantity and the mode are optionally selected.
When this simulation is executed, the following execution start window is displayed.
When [OK] key or [START] key is pressed, the machine exits the simulation mode.
Enter a desired coy mode and a desired copy quantity.
Press [START] key, and intermittent aging will be started.
It is canceled by turning off the power or executing a simulation with the hard reset.
08
Shifting with warm-up display
Used to measure the warm-up time.
When this simulation is executed, the following warm-up window is displayed.
The time required for starting the warm-up and completing the initializing operation and shifting to the stand-
by state is displayed.
*
Though [CA] key is pressed, the machine does not enter the aging mode of intermission 0 sec.
Press [CA] key to exit the simulation mode.
(The aging function is omitted from SIM 07-01.)
Note: Toner supply operation is not performed during this simulation.
08
01
Developing bias output
Used to check the developing bias output.
When this simulation is executed, the following execution start window is displayed.
When [OK] key or [START] key is pressed, the developing bias signal is turned ON for 30sec. When
measuring the actual output value, however, use SIM 25-01.
After completion of the process, the machine returns to the sub code input window.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Interrupts output operation and shifts to the sib code input window.
Main
code
Sub
code
Contents
Remark
Sim7-1 W-UP C-MODE
WARMING UP.
[CA] key
1
(Warming up window)
Sim7-1 W-UP C-MODE
WARM UP COMPLETED.
10
(Warming up completion window)
Ready to copy.
S
100%
8 1/2
×
11
(Copy window)
Sim7-6 INTERVAL SET
AER YOU SURE? EXEC
AGING INTERVAL
(Execution start window)
Ready to copy.
S
100%
8 1/2
×
11
(Copy window)
Sim7-8 W-UP C-MODE
WARMING UP.
1
(Warming up window)
Sim7-8 W-UP C-MODE
WARM UP COMPLETED.
10
(Warming up completion window)
Sim8-1 DV BIAS
PRESS OK KEY EXEC
Sim8-1 DV BIAS
EXEC
[OK] key or [START] Key
(Execution start window)
(Execution window)
Содержание MX-M182D
Страница 125: ...MX M182 DISASSEMBLY AND ASSEMBLY 10 19 H Paper entry sensor I Paper empty sensor 1 1 2 3 1 2 3 ...
Страница 144: ...Memo ...
Страница 145: ...Memo ...