Basic Operation
-29
"
On-screen Display (Example)
➝
➝➝
Using Analog
RGB
Using
Component
INPUT 2 Mode
Using S-Video
INPUT 3 Mode
Using Video
3
Press
,
or
on the
remote control to select the
INPUT Mode.
•
Pressing
on the projector switches
the inputs in the following order:
→
INPUT 1
→
INPUT 2
→
INPUT 3
Note
•
When no signal is received, “NO
SIGNAL” will be displayed. When a
signal that the projector is not pre-
set to receive is received, “NOT
REG.” will be displayed.
About the INPUT Modes
Used for projecting im-
ages from equipment that
sends RGB signals or
Component signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
Used for projecting im-
ages from equipment
connected to the S-
VIDEO input terminal.
Used for projecting im-
ages from equipment
connected to the VIDEO
input terminal.
INPUT 1
(RGB/
Component)
INPUT 2
(S-Video)
INPUT 3
(Video)
INPUT 1 Mode
Using
DVI digital
4
Press
or
on the remote
control to adjust the volume of
the speaker.
Note
•
Pressing
will raise the volume.
Pressing
will lower the volume.
•
On the projector, the volume can be
adjusted by pressing
or
.
•
,
on the projector operate
as cursor buttons (
,
) when
selecting setup or adjustment
functions while adjusting menus or
the lens.
VOLUME
buttons
Содержание M20X - Notevision Digital Video Projector
